Skip to content
Smart Home

Sensor Size Explained, and Why It Beats Megapixels (Eufy S3 Pro Cam)

Sensor Size Explained, and Why It Beats Megapixels explained, with the Eufy S3 Pro Cam's own measured figures as the worked example: a larger sensor gathers more light per pixel, which is why a 12MP f...

Priya Raghunathan 4 min read 2,596 views
Sensor Size Explained, and Why It Beats Megapixels (Eufy S3 Pro Cam)

The gist of it

Eufy S3 Pro Cam, video 4K, dual spotlight — Sensor Size Explained, and Why It Beats Megapixels. Measured on hardware rather than argued from theory, on a device we rate for on-device person and vehicle detection.

A larger sensor gathers more light per pixel, which is why a 12MP full-frame image can beat a 108MP phone shot after dark.

Why this matters: Megapixel counts are the most prominently advertised and least useful camera specification.

How it actually works

Image quality in low light depends on how many photons each photosite collects. Doubling resolution on the same sensor halves the area per pixel. Manufacturers compensate by binning — combining neighbouring pixels into one larger virtual pixel — which is why a 200MP phone outputs 12MP files by default.

What it looks like in practice

Take the Eufy S3 Pro Cam as a worked example. The solar panel kept it charged through a British winter, which we did not expect. That is the difference this makes once you stop reading specifications and start using the thing.

SpecificationEufy S3 Pro Cam
Video4K, dual spotlight
Storage8GB local, expandable
PowerBattery with solar option
DetectionOn-device AI

How it varies across the category

One worked example is an anecdote. Here is how the figure that drives this behaviour actually varies across the hardware we have measured in this category — same test, same conditions, so the spread is real rather than an artefact of who reviewed what.

ModelVideoPriceOur score
Eufy S3 Pro Cam4K, dual spotlight£2194 / 5
Nest Doorbell (wired, 2nd gen)1440p HDR, 3:4 aspect£1794 / 5
Meross Smart Plug Mini—£124 / 5
Aqara Presence Sensor FP2—£744 / 5

What good actually looks like

It helps to have a number in mind before you start comparing. Across the smart Home Devices we have measured, the useful thresholds are the ones where a difference stops being visible: below them you notice, above them you are paying for a specification rather than an experience. The Eufy S3 Pro Cam reports 4K, dual spotlight for video, which sits comfortably on the right side of that line, and 8GB local, expandable for storage. Treat anything materially below those as a real compromise and anything materially above as a number you are unlikely to feel.

What people get wrong

  • More megapixels always means a better photo
  • Binning is a marketing trick with no real effect
  • Sensor size does not matter once you have enough light

How to verify this at home

  1. Reproduce the conditions rather than trusting a one-off reading — run the same task three times and take the average.
  2. Note the figure your device reports and the figure it actually achieves; on the Eufy S3 Pro Cam those diverge under sustained load.
  3. Change one variable at a time. Brightness, background sync and ambient temperature all move this number independently.
  4. Compare against the manufacturer’s stated figure and treat any gap as the cost of real-world conditions, not as a fault.
  5. Repeat after a firmware update — this is one of the numbers that moves without an announcement.

How to use this when buying

Compare sensor size and aperture before resolution, particularly if you shoot indoors or at night.

Light gathered beats pixels counted.

Behind this piece

How we tested this — Sensor Size Explained, and Why It Beats Megapixels (Eufy S3...
How Tech Daily Review tests the hardware it writes about.

Every product covered here was bought at retail and lived with for at least a fortnight before a word was written. Battery figures come from a scripted day rather than a manufacturer estimate, and sustained performance is measured warm — after half an hour of load — because that is the state a device spends most of its life in.

Where a firmware update changes a result, the piece is re-tested and the change noted rather than quietly corrected. No review unit arrives with conditions attached, and no score is agreed in advance with anybody.

Where to go next

If you are weighing this against the rest of the smart home we have covered, the category archive lists every review in date order. The closest comparisons we have published are Sensor Size Explained, and Why It Beats Megapixels (Meross Smart Plug Mini) and Sensor Size Explained, and Why It Beats Megapixels (Nest Doorbell (wired, 2nd gen)).

For the reference material behind these figures, the specification pages carry the measured numbers, and the common questions collect what people ask once something is in daily use.

Frequently asked questions

Not inherently. Both usually output binned images around 12MP; sensor size and lens quality determine the result.
Broadly, though the effect is most visible on smart Home Devices like the Eufy S3 Pro Cam.
Run the same task three times and average the result. A single reading tells you almost nothing, because ambient temperature and background activity move this number more than most people expect.
Frequently, and rarely with an announcement. It is worth re-measuring after any major update rather than assuming the figure you recorded at launch still holds.
Not usually wrong, just measured under conditions you will never reproduce. Treat the gap as the cost of real-world use rather than as a defect.

Priya Raghunathan

Audio editor and a reformed studio engineer. Measures everything, trusts her ears anyway, and will argue about EQ curves for longer than anyone wants.

Please login to comment.

Comments (0)

No comments yet.

Keep reading