Skip to content
Gaming

Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (ROG Ally X)

Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC explained, with the ROG Ally X's own measured figures as the worked example: the codec determines how audio is compressed for transmission. It m...

Maya Okonkwo 4 min read 2,141 views
Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (ROG Ally X)

In brief

ROG Ally X, play time 3h 10m in demanding titles — Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC. Measured on hardware rather than argued from theory, on a device we rate for it runs anything Windows runs, including Game Pass.

The codec determines how audio is compressed for transmission. It matters less than fit and tuning, but it is not nothing.

Why this matters: Codec support is one of the few hard compatibility facts worth checking before buying wireless audio.

What is going on underneath

SBC is the mandatory baseline every device supports. AAC is efficient and what Apple devices use. aptX variants target lower latency. LDAC carries the most data but needs a supporting source and drops back under interference. A codec sets a ceiling on quality; it does not guarantee it.

In daily use

Take the ROG Ally X as a worked example. It ran 31 percent faster than the Steam Deck at the same wattage. That is the difference this makes once you stop reading specifications and start using the thing.

SpecificationROG Ally X
Display7in IPS, 120Hz, 500 nits
ChipAMD Ryzen Z1 Extreme
RAM24GB LPDDR5X
Storage1TB NVMe
Weight678g
Battery80Wh
Play time3h 10m in demanding titles

The same concept across four devices

One worked example is an anecdote. Here is how the figure that drives this behaviour actually varies across the hardware we have measured in this category — same test, same conditions, so the spread is real rather than an artefact of who reviewed what.

ModelDisplayPriceOur score
ROG Ally X7in IPS, 120Hz, 500 nits£7994 / 5
Steam Deck OLED7.4in OLED, 90Hz, 1000 nits HDR£4795 / 5
Switch OLED7in OLED, 60Hz, 400 nits£3094 / 5
PlayStation 5 Slim—£4794 / 5

What counts as good here

It helps to have a number in mind before you start comparing. Across the gaming Hardware we have measured, the useful thresholds are the ones where a difference stops being visible: below them you notice, above them you are paying for a specification rather than an experience. The ROG Ally X reports 7in IPS, 120Hz, 500 nits for display, which sits comfortably on the right side of that line, and AMD Ryzen Z1 Extreme for chip. Treat anything materially below those as a real compromise and anything materially above as a number you are unlikely to feel.

What people get wrong

  • LDAC always sounds better, when it drops to lower bitrates under congestion
  • Codec choice matters more than tuning or fit — it does not
  • You can hear the difference on any source material

How to check this on your own device

  1. Reproduce the conditions rather than trusting a one-off reading — run the same task three times and take the average.
  2. Note the figure your device reports and the figure it actually achieves; on the ROG Ally X those diverge under sustained load.
  3. Change one variable at a time. Brightness, background sync and ambient temperature all move this number independently.
  4. Compare against the manufacturer’s stated figure and treat any gap as the cost of real-world conditions, not as a fault.
  5. Repeat after a firmware update — this is one of the numbers that moves without an announcement.

Putting it to work

Check your phone supports the codec before paying extra for it, and prioritise fit and tuning over the acronym.

Buy for fit and tuning first. Treat the codec as a tie-breaker.

Behind this piece

How we tested this — Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (ROG...
How Tech Daily Review tests the hardware it writes about.

Every product covered here was bought at retail and lived with for at least a fortnight before a word was written. Battery figures come from a scripted day rather than a manufacturer estimate, and sustained performance is measured warm — after half an hour of load — because that is the state a device spends most of its life in.

Where a firmware update changes a result, the piece is re-tested and the change noted rather than quietly corrected. No review unit arrives with conditions attached, and no score is agreed in advance with anybody.

Where to go next

If you are weighing this against the rest of the gaming we have covered, the category archive lists every review in date order. The closest comparisons we have published are Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (Steam Deck OLED) and Understanding Bluetooth Codecs: SBC, AAC, aptX and LDAC (Switch OLED).

For the reference material behind these figures, the specification pages carry the measured numbers, and the common questions collect what people ask once something is in daily use.

Frequently asked questions

It can carry more data, but on a congested connection it falls back. On an iPhone it is unavailable anyway, so AAC is the practical ceiling.
Broadly, though the effect is most visible on gaming Hardware like the ROG Ally X.
Run the same task three times and average the result. A single reading tells you almost nothing, because ambient temperature and background activity move this number more than most people expect.
Frequently, and rarely with an announcement. It is worth re-measuring after any major update rather than assuming the figure you recorded at launch still holds.
Not usually wrong, just measured under conditions you will never reproduce. Treat the gap as the cost of real-world use rather than as a defect.

Maya Okonkwo

Editor-in-chief. Fifteen years reviewing phones, and still the first person in the office to complain about a curved display. Runs our battery testing rig.

Please login to comment.

Comments (0)

No comments yet.

Keep reading